Water spraying or gushing from a pipe, wall, ceiling, or under a sink. Here's what to do about burst pipes in Tampa — including the local factors that change the advice.
Do this right now
Close the nearest valve first
If the burst is at a toilet, sink, or appliance, turn its small stop valve clockwise. This can stop the flow in seconds.
Shut off the main water valve
Can't find a local valve — or the break is in a wall? Close the main shutoff for the whole house now. Don't wait until you 'find' it; close first, label later.
Kill power near the water
If water is near outlets, appliances, or the breaker panel, stay out of standing water and don't touch breakers with wet hands.
Drain pressure safely
After the main is off, open a cold faucet at the lowest point in the house to relieve line pressure — only if it creates no new hazard.
Call for repair
Call (844) 699-1165. Tell us where the break is (wall, ceiling, crawlspace, under sink) and what the pipe looks like (copper, PEX, galvanized) if you can tell.
Burst Pipe in Tampa? Talk to a local pro now.
Free for homeowners · 24/7 · Licensed local pros
What makes burst pipes different in Tampa
- In Tampa, rare freezes happen — exposed pipes on the coldest Tampa nights have burst
- Homes here are often mix of historic bungalows, mid-century ranches, and new slab construction — which changes where pipes run and how hard they are to reach.
- Sinkhole Alley runs through this region — limestone dissolution shifts ground under pipes
- Older neighborhoods still run cast-iron drains that are reaching end of life simultaneously
Neighborhoods
If you're in Ybor City, Hyde Park, South Tampa, St. Petersburg, Clearwater, Brandon, Westshore, Seminole Heights, Carrollwood, Riverview, or anywhere across the Tampa metro — Tampa, St. Petersburg, Clearwater, Brandon, Largo — the steps above apply. Call (844) 699-1165 and mention your neighborhood so we match you with a pro who knows the area.
What to tell the pro when you call
- Your address and whether the main water is currently on or off
- Where the break is: interior wall, ceiling, crawlspace, basement, under a fixture
- Pipe material if visible — copper, PEX, CPVC, or galvanized
- What caused it if you know: freeze, renovation damage, corrosion, high pressure
- How much water reached floors, walls, or electrical areas
Not quite your problem?
| Slow drip or damp spot with no spray | Leak detection in Tampa → |
| Ice in the line, little flow, not yet spraying | Frozen pipes in Tampa → |
| Water coming from the water heater tank | Leaking water heater in Tampa → |
Burst Pipe in Tampa — FAQs
Are burst pipes common in Tampa?
What should I mention about my Tampa home when I call?
Can I patch a burst pipe myself temporarily?
How much does burst pipe repair cost?
More Tampa plumbing guides
Main Water Shutoff Valve
You don't know where your main shutoff is (most common 'symptom').